KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 69

Step 26: Attach Elbow Assembly to Flange Assembly
Note: Keep all bolts loose until further step.
A: Fit one of the Elbow Assemblies to the Flange Assembly by lining up the arrows on each assembly. Attach
Elbow Assembly to Flange Assembly using 6 (PB1) ¼ x 3/4" Pan Bolts and Square Lock Nut. (fig. 26.1, 26.2 and
26.3)
B: Attach one of the Elbow assemblies to another Elbow Assembly making sure to line up the arrows on each
assembly. Attach 6 (PB1) ¼ x 3/4" Pan Bolts with Square Lock Nut. Repeat this instruction for 2 more. (fig. 26.2
and 26.3)
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Fig. 26.1
Fig. 26.3
Align each elbow using the
molded arrows.
Fig. 26.2
Top Slide Bolt Holes
Square
Lock Nut
Elbow
Assembly
69
Quadrex Driver
Use special driver provided
in locations where the curve
of the elbow are difficult to
reach with a standard driver.
¼ x 3/4"
Pan Bolt
Flange
Assembly
Other Parts
1 x Quadrex Driver
24 x 1/4 x 3/4" Pan Bolt
24 x 1/4" Square Lock Nut