KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 30

Step 7: Attach Diagonals
Part 1
A: Loosely attach (071) SW Ground to (072) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat washer
and t-nut) then place (072) Diagonal tight and flush to the front of (031) Front Wall Panel. (071) SW Ground to
be flush to the bottom of (032) SW Wall Panel. (fig. 7.1 & 7.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (072) Diagonal to (031) Front Wall Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 7.1 & 7.2)
C: Make sure bottom of (071) SW Ground is flush to bottom of (032) SW Wall Panel then attach with 2 (S11) #8
x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 7.1 & 7.2)
Fig. 7.1
Front Wall
Wood Parts
1 x SW Ground 5/4 x 4 x 14-1/4"
071
1 x Diagonal 1-1/4 x 3 x 22"
072
SW Wall
Hardware
WB9
1 x 5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
1 x 1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x #8 x 3" Wood Screw
S4
2 x #8 x 2" Wood Screw
S11
30
Fig. 7.2
5/16" Flat
Washer
WL5
031
5/16"
T-Nut
5/16" Flat
WB9
Washer
Flush
072
032
071
S11
Flush
S4