KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 22

Step 4: Join Swing and Slide Wall Assemblies
Part 1
A: With at least two helpers lift the Slide Wall Assembly and Swing Wall Assembly so the (021) Narrow Back
Panel and (023) Narrow Front Panel meet with (033) Back Rock Panel and (031) Front Wall Panel and are tight
together as shown in (fig. 4.1).
B: Make sure the assembly is square then on the inside of the assembly, tight to (022) Slide End Panel and flush
to the bottom of the panels attach 1 (041) Short Floor Joist to (021) Narrow Back Panel and (033) Back Wall
Panel and 1 (042) Floor Joist to (023) Narrow Front Panel and (031) Front Wall Panel with 7 (S7) #12 x 2" Pan
Screws. (fig. 4.1 & 4.2 & 4.3)
Fig. 4.1
Slide Wall
Assembly
023
022
021
Fig. 4.3
031
Wood Parts
1 x Short Floor Joist 1-1/4 x 3 x 29-3/4"
041
1 x Floor Joist 1-1/4 x 3 x 40-3/4"
042
041
042
S7
x 4
7 x
Swing Wall
Assembly
031
032
033
Fig. 4.2
022
Tight
Flush
(both sides)
042
Hardware
#12 x2" Pan Screw
S7
22
033
021
x 3
S7
041