KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 21

Step 3: Swing Wall Assembly
A: Place (031) Front Wall Panel against the left side of (032) SW Wall Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (031)
Front Wall Panel to (032) SW Wall Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 3.1 & 3.2)
B: Place (033) Back Rock Panel against the right side of (032) SW Wall Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(032) SW Wall Panel to (033) Back Rock Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 3.1 & 3.3)
Fig. 3.2
Flush
031
Notice (031) Front Wall
Panel overlaps (032)
SW Wall Panel
WL5
Wood Parts
1 x SW Wall Panel 1-1/4 x 37 x 92"
032
1 x Front Wall Panel 1-1/4 x 43 x 92"
031
1 x Back Wall Panel 1-1/4 x 43 x 92"
033
032
Fig. 3.1
8 x
033
032
Flush
Hardware
1/4 x 2-1/2" Wafer Lag
WL5
21
Fig. 3.3 Flush
032
Notice (032) SW Wall
Panel overlaps (033)
Back Wall Panel
WL5
WL5