KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 46

Step 14: Swing Beam Assembly
Part 1
A: Attach 6 Heavy Duty Swing Hangers to (141) Engineered SW Beam using 2 (G13) 5/16 x 6-1/8" Hex Bolt
(with 2 flat washers, plastic formed washer and lock nut) per swing hanger, as shown in (fig. 14.1 and 14.2).
B: Attach 1 Spring Loaded Quick Link to each Heavy Duty Swing Hanger. (fig. 14.3)
C: Install 1 (WB7) 5/16 x 3" Wafer Bolt (with flat washer and t-nut) in the middle bolt hole, from the bottom
up, in (141) Engineered SW Beam as shown in (fig. 14.1 and 14.4). IT IS IMPORTANT THAT THIS BOLT IS
ATTACHED. IT WILL MINIMIZE CHECKING OF WOOD.
D: Attach Cedar Summit Plaque to centre of (141) Engineered SW Beam (over top of t-nut) using 4 (S38) #7 x
1-1/8" Pan Screws. (fig. 14.5)
Fort End
Heavy Duty
Swing Hanger
Fig. 14.2
G13
5/16"
T-Nut
Fig. 14.4
5/16" Flat
Washer
WB7
Wood Parts
1 x Engineered SW Beam 4 x 6 x 92"
141
141
5/16"
Lock Nut
5/16" Flat
Washer
Plastic
Formed
Washer
141
5/16" Flat
Washer
141
Spring Loaded Quick
Link in the closed
position
12 x 5/16 x 6-1/8" Hex Bolt
G13
(5/16" flat washer x 2, 5/16" lock nut & plastic formed washer)
1 x 5/16 x 3" Wafer Bolt
WB7
(5/16" flat washer, 5/16" t-nut)
4 x S38 #7 x 1-1/8" Pan Screw
Heavy Duty
Swing Hanger x 6
Heavy Duty
Swing Hanger
Caution: The Spring Loaded Quick Link
must be attached to the Heavy Duty Swing
Hanger in the closed position. (fig. 14.4)
Hardware
46
Fig. 14.1
Swing End
Fig. 14.3
Spring
Loaded
Quick Link
Cedar Summit
Fig. 14.5
Plaque
S38
Other Parts
6 x Heavy Duty Swing Hangers
6 x Spring Loaded Quick Link
1 x Cedar Summit Plaque
x 4
141