KidKraft Cedar Summit Adventure Ridge Playset Installation And Operating Instructions Manual page 37

Step 10: Install Climbing Rope
Part 1
A: Tie a knot in one end of the rope. (Fig. 10.4)
B: Position (101) Top Rope so that the notched out side is facing up. Place the rope so that it sits in the notch then at the
top of the opening in the Vertical Wall place (101) Top Rope tightly against the underside of the panel. Make sure that the
knotted end of the rope is on the inside of the fort as shown in (fig.10.1). Attach (101) Top Rope using 5 (S4) #8 x 3" Wood
Screws (fig.10.1)
C: Tie a second knot in the rope on the opposite side of (101) Top Rope so that the knots are tight to the panel on both sides.
D: Tie 4 knots in the rope making sure that they are evenly spaced from top to bottom. (fig. 10.2 & 10.3)
E: Feed rope through hole in bottom of (0890) Vertical Rock Board Short Wide and pull tight. Tie off the rope securely with a
single knot. (fig.10.2 & 10.3 & 10.4)
F: IMPORTANT: MAKE SURE THE ROPE IS TIGHT
Fig. 10.1
Inside View
Fig. 10.3
Wood Parts
1 x Top Rope 1-1/4 x 2 x 16-15/16"
101
101
x 5
S4
Hardware
5 x #8 x 3" Wood Screw
S4
37
Outside
Fig. 10.2
0890
Rope
Fig. 10.4
Rope
Other Parts
1 x Rope