Configuring Mld - Lenovo RackSwitch G8264CS Application Manual

Configuring MLD

1. Turn on MLD globally.
2. Create an IPv6 interface.
3. Enable MLD on the IPv6 interface.
4. Configure the MLD parameters on the interface: version, robustness, query
response interval, MLD query interval, and last listener query interval.
© Copyright Lenovo 2017
Following are the steps to enable MLD and configure the interface parameters:
RS 8264CS(config)# ipv6 mld
RS 8264CS(config-router-mld)# enable
RS 8264CS(config-router-mld)# exit
RS 8264CS(config)# interface ip 2
RS 8264CS(config-ip-if)# enable
RS 8264CS(config-ip-if)# ipv6 address 2002:1:0:0:0:0:0:3
RS 8264CS(config-ip-if)# ipv6 prefixlen 64
RS 8264CS(config-ip-if)# ipv6 mld enable
RS 8264CS(config-ip-if)# ipv6 mld version <1‐2>
RS 8264CS(config-ip-if)# ipv6 mld robust <1‐10>
RS 8264CS(config-ip-if)# ipv6 mld qri <1‐256>
RS 8264CS(config-ip-if)# ipv6 mld qintrval <1‐608> (In seconds)
RS 8264CS(config-ip-if)# ipv6 mld llistnr <1‐32>
(MLD version)
(Robustness)
(In seconds)
(In seconds)
Chapter 27: Multicast Listener Discovery
443