Configuring MLD
1. Turn on MLD globally.
2. Create an IPv6 interface.
3. Enable MLD on the IPv6 interface.
4. Configure the MLD parameters on the interface: version, robustness, query
response interval, MLD query interval, and last listener query interval.
© Copyright Lenovo 2015
Following are the steps to enable MLD and configure the interface parameters:
CN 4093(config)# ipv6 mld
CN 4093(config-router-mld)# enable
CN 4093(config-router-mld)# exit
CN 4093(config)# interface ip 2
CN 4093(config-ip-if)# enable
CN 4093(config-ip-if)# ipv6 address 2002:1:0:0:0:0:0:3
CN 4093(config-ip-if)# ipv6 prefixlen 64
CN 4093(config-ip-if)# ipv6 mld enable
CN 4093(config-ip-if)# ipv6 mld version <1-2>
CN 4093(config-ip-if)# ipv6 mld robust <1-10>
CN 4093(config-ip-if)# ipv6 mld qri <1-256>
CN 4093(config-ip-if)# ipv6 mld qintrval <1-608>
CN 4093(config-ip-if)# ipv6 mld llistnr <1-32>
(MLD version)
(Robustness)
(In seconds)
(In seconds)
(In seconds)
Chapter 28: Multicast Listener Discovery
431