Single Loop Operation in Manual Mode
Single Loop Operation in Manual Mode
This section describes operations when a control loop is in manual. The faceplate
displays and control button operations resemble the examples shown in
Figure 88. Single Loop Operation in Manual Mode - Faceplate
204
indicates that the controller is in manual.
Current output value display [OP] is in percent
and can be adjusted using:
•
the output slider
•
the [OP] entry menu
indicates local setpoint is active and can be
changed. Use the slider or the value box [SP]
to change the value with confirmation. Since
the controller is in manual, the process is
following the manual controller output and not the
controller algorithm.
Section 8 Operation Examples
Figure
3BUR002418-600 A
88.