Section 8 Operation Examples - ABB 800xA Operation

Typical Operator Activities
All operator activities related to ongoing operations are performed using the
operation displays provided with 800xA for MOD 300. Tuning parameters can be
accessed from these displays. The ability to make tuning adjustment for alarm and
control parameters depends on the access rights of the user.
This section describes basic operator activities to illustrate use of the MOD CCF
displays in the 800xA System environment. These activities include:
•
•
•
•
•
•
•
•
•
•
3BUR002418-600 A

Section 8 Operation Examples

Selecting and viewing a control loop.
Monitoring process variable input and setpoint.
Monitoring output to the control device.
Monitoring alarm status.
Acknowledging alarms.
Changing the local setpoint.
Changing operating mode between manual and automatic.
Changing output value while in manual mode.
Changing setpoint source between local setpoint and remote setpoint
(if enabled).
Changing ratio and bias values (if configured).
193