Smoothstart Start-Up Sequence; S100 Warmstart - ABB 800xA Operation

Section 7 I/O Displays
Value
Diagnostics

Smoothstart Start-up Sequence

Upon acquisition of an S100 I/O device, a diagnostic message identifying the device
will be issued to the user. Use the MOD Faceplate or Loop FCM Display to see the
following conditions:
•
•
Upon acquisition the user must:
1.
2.
3.
4.
5.

S100 Warmstart

Actions Upon Node Startup
Upon node startup, outputs to all devices are disabled. The database is downloaded
with each CCF loop output FCM in its initial output mode and each device loop
3BUR002418-600 A
The actual value of the input from the process or the output value
sent to the process.
For an output field, you can change the value of an output channel
by selecting it and entering a value.
Not used.
See the S100 I/O instruction for error message information.
For an analog I/O device, whether the CCF tag which references a channel has
an Output FCM in the Manual mode.
For a digital I/O device, whether the CCF device loop which references a
channel has NO COMMAND as its DEV_CMND attribute.
Acknowledge a device acquisition diagnostic message.
Call up the corresponding MOD Faceplate or Loop FCM Display to find out
what loops are affected.
Make any necessary modifications to synchronize the control system with the
current outputs.
Commission any affected CCF output FCMs by setting their output modes to
AUTO.
Commission any affected CCF Device loops by issuing device commands as
required.
Smoothstart Start-up Sequence
165