Mod30_Mod300_Map - ABB 800xA Operation

Appendix A Runtime Templates
INITIAL RESULT Field
This field specifies an initial result for the FCM. It is available for the first scan of
the FCM. You can view and change the value during runtime via the Loop/FCM
Display. Valid entry is a real number.
HIGH LIMIT Field
This field specifies a high limit for the result of the FCM if the entry in the
ENABLE HIGH LIMIT field is YES. The limit applies to the final result only, not
intermediate calculations. When the result is limited, the HI_FLAG attribute is set to
1. TCL can set events to watch this flag or you can acquire its value using Get
FCMs. Valid entry is a real number.
LOW LIMIT Field
This field specifies a low limit for the result of the FCM if the entry in the ENABLE
LOW LIMIT field is YES. The limit applies to the final result only, not intermediate
calculations. When the result is limited, the LO_FLAG attribute is set to 1. TCL can
set events to watch this flag or you can acquire its value using Get FCMs. Valid
entry is a real number.
ENABLE HIGH LIMIT Field
This field enables and disables the high alarm limit checking. Valid entries are: YES
(enabled), NO (disabled).
ENABLE LOW LIMIT Field
This field enables and disables the low alarm limit checking. Valid entries are: YES
(enabled), NO (disabled).

MOD30_MOD300_MAP

This FCM is used when the MOD 300 control system communicates with a MOD
30 Instrument. This FCM is addressed in detail in instruction manual C120,
Taylor™ MOD 30™ Interface User's Guide.
3BUR002418-600 A
MOD30_MOD300_MAP
279