Engineer Tuning Displays For A Device Loop - ABB 800xA Operation

Section 3 CCF Displays
Tuning changes are made to database attributes by first changing the information on
the templet and then saving the templet information to the database by selecting the
SAVE button. If the save process is not successful, a message describing the
problem is displayed. After corrective action is taken, you can re-attempt the save
process. Use the X button to exit the templet.
Tuning changes affect both the active database in the subsystem containing the
loop and the installed database on the disk in the node where the AdvaBuild
configuration software resides. Matching the installed database with the
operational database allows tuning changes to remain in effect when a subsystem
or control module is rebooted.
Templets originally used to configure the database retain the old value until the
database is decompiled. Instructions for decompiling a database are provided in
AdvaBuild Basic Functions User's Guide for the Advant Station-based
AdvaBuild software.
Runtime Version of Breakpoint Sets Templet
The runtime version of the Breakpoint Sets Templet (Linearization Update Display)
is used to change the values of a specific breakpoint set without having to recompile
and install the entire CCF configuration of the node. The templet is accessed via the
Loop FCM Display LINEAR TBL button when a TABLE FCM is selected.
Set the X VALUE, Y VALUE pairs in the edit window using floating point numbers.
Enter from 2 up to 11 x,y pairs. When all required changes to the values are made,
send the new values to the database by selecting the SAVE button. If the save
process is not successful, a message describing the problem is displayed.
SAVE changes both the active database in the subsystem containing the loop and
the installed database on the disk in the node where the configuration software
resides. However, the Breakpoint Sets Templets originally used to configure the
database is not immediately modified. It retains the old values until the database is
decompiled. Instructions for decompiling a database are provided in AdvaBuild
Basic Functions User's Guide for the Advant Station-based AdvaBuild software.
There is no log of the changes made to the breakpoint sets.

Engineer Tuning Displays for a Device Loop

Access the runtime version of the Device Loop Templet by:
3BUR002418-600 A
Engineer Tuning Displays for a Device Loop
57