HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 89

cli% showport -sfp -ddm 0:1:1 1:1:1
--------------Port 0:1:1 DDM--------------
--Type-- Units Reading Low
Temp C 29
Voltage mV 3339
TX Bias mA 8
TX Power uW 478
RX Power uW 522
--------------Port 1:1:1 DDM--------------
--Type-- Units Reading Low
Temp C 33
Voltage mV 3332
TX Bias mA 7
TX Power uW 476
RX Power uW 98
port Example 2
Component -Summary Description- Qty
Port Missing SFPs
Component -Identifier- -Detailed Description--
Port port:0:3:1
port Suggested Action 2
FC node-ports that normally contain SFPs will report an error if the SFP has been removed. The condition
can be checked using the showport -sfp command. In this example, the SFP in 1:1:1 has been
removed from the Adapter:
cli% showport -sfp
N:S:P -State- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK HP-F
0:1:2 OK HP-F
1:1:1 - -
1:1:2 OK HP-F
port Example 3
cli% checkhealth -detail port
port Suggested Action 3
Check the state of the port with showport. If a port is offline, it was deliberately put in that state using the
controlport offline command. Offline ports might be restored using controlport rst.
-Warning- --Alarm--
High Low High
-5 85 -10 90
3000 3600 2900 3700
2 14 1 17
158 562 125 631
15 1000 10 1258
-Warning- --Alarm--
High Low High
-5 85 -10 90
3000 3600 2900 3700
2 14 1 17
158 562 125 631
15 1000 10 1258
1
SFP is missing
8.5 No
8.5 No
8.5 No
No
No
- - -
No
No Yes
Yes Yes
- -
Yes Yes
Troubleshooting 89