HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 38

Figure 19: Installing an HPE 3PAR StoreServ 7000 Storage LFF Drive
9. Repeat the steps for each Drive.
IMPORTANT:
For proper airflow and cooling, a slot-filler Blank must remain installed in all unused Drive bays.
Verification:
10. Verify that the Drives have been admitted and integrated into the storage system.
Confirm on the drives that the Status LED is solid green.
Within six minutes (depending on the storage system load and the size of the upgrade), the Drives
will be admitted, integrated, assigned an ID number, and the storage system starts to initialize the
chunklets to ready for use. Chunklet initialization can take several hours to complete and the output
of the available capacity is displayed.
11. After the component replacement, initiate Check Health of the storage system.
a. From the HPE 3PAR SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
12. Install the Bezel on the enclosure front.
a. Insert the Bezel into the enclosure right side (1).
b. Press in the release tab (2).
c. Insert the Bezel into the enclosure left side (3).
d. Lock the Bezel (4) (optional).
38 Upgrade of the storage system