HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 24

a. On the Drive, press the release button to open the handle.
b. With the latch handle of the Drive fully extended, align and slide the Drive into the bay until the
handle begins to engage (1).
c. To seat the Drive into the Drive bay, close the handle (2).
Figure 10: Installing an HPE 3PAR StoreServ 7000 Storage SFF Drive
Figure 11: Installing an HPE 3PAR StoreServ 7000 Storage LFF Drive
Verification:
11. Observe the newly installed Drive and confirm the Fault LED is off and the Status LED is solid green.
The change in the LEDs may take several minutes as the Drive is prepared for use by the system.
12. Verify the state of the replacement Drive.
24 Service of the hardware components