HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 36

Procedure
Preparation:
1. Unpack the component and place on an ESD safe mat.
2. Connect to the HPE 3PAR Service Processor (SP).
Browse to either the IP address or hostname: https://<sp_ip_address> or https://
<hostname> .
3. Log in to the HPE 3PAR SP.
With the 3parcust account credentials, the HPE 3PAR Service Processor Onsite Customer Care
(SPOCC) interface displays.
4. Initiate Check Health of the storage system.
a. From the HPE 3PAR SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
A pop-up window appears showing a status message while the health check runs.
NOTE:
When running the Health Check using Internet Explorer, the screen might remain blank
while information is gathered. This process could take a few minutes before displaying
results. Wait for the process to complete and do not attempt to cancel or close the browser.
When the health check process completes, it creates a report and displays in a new browser
window.
c. To review the report, click either Details or View Summary.
CAUTION:
If health issues are identified during the Check Health scan, resolve these issues before
continuing. Refer to the details in the Check Health results and contact HPE support if
necessary.
5. Obtain the current Drive count.
From the SSMC interface, select Storage Systems > Drive Enclosures > Physical Drives.
6. Remove the Bezel from the enclosure front.
a. Unlock the Bezel if necessary (1).
b. Press the release tab (2).
c. Rotate the Bezel away from the enclosure left side (3).
d. Pull the Bezel out from the enclosure right side (4).
36 Upgrade of the storage system