HPE 3PAR StoreServ 7000 Storage Controller Node Enclosure rear view
Item
6
Power connection 1
7
Serial number
Drives
The HPE 3PAR StoreServ 7000 Storage Drives are installed in the drive bays at the front of either the
Controller Node Enclosures or expansion Drive Enclosures. Drives come in two physical sizes installed in
carriers (magazines).
HPE 3PAR StoreServ 7000 Storage Drive types:
•
Fast class (FC) drive
•
Near line (NL) drive
•
Solid-state drive (SSD)
SFF drives are available in all three types: FC, NL, and SSD.
LFF drives are available only in types: NL or SSD.
For the HPE 3PAR StoreServ 7450 Storage, all flash array (AFA) model, only SSDs are supported.
HPE 3PAR StoreServ 7000 Storage Drive sizes:
•
SFF 6.4 cm (2.5 in) drives
•
LFF 8.9 cm (3.5 in) drives
Maximum HPE 3PAR StoreServ 7000 Storage Drives supported:
•
24 SFF drives per enclosure
•
24 LFF drives per enclosure
Enclosures front view
The fronts of the Controller Node Enclosure and expansion Drive Enclosures contain the Drive Bays for
installing the drives for the storage system. Each Drive Bay is assigned a number for locating Drives in
the storage system.
Description
This power connection requires a power cable to be attached between the
power supply and an independent electrical source. This electrical source
must support the entire power load of the enclosure and have its own
circuit breaker.
The 10-character serial number for the storage system is required for the
software setup. The serial number is on the Controller Node Enclosure
next to the rightmost Power Cooling Module (PCM 1) power switch.
Drives
117