HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 40

TIP:
When putting the storage system in maintenance mode or editing the maintenance mode,
you need to specify the duration in hours and a description of the reason for the
maintenance window.
To edit the maintenance window, select Actions > Set maintenance mode, and then click
the Edit icon next to the maintenance window.
5. Initiate Check Health of the storage system.
a. From the SC interface, select Systems.
b. Select Actions > Check health, and then select the Check health button. A scan of the storage
system will be run to make sure that there are no additional issues.
A scan of the storage system will be run to make sure that there are no additional issues.
CAUTION:
If health issues are identified during the Check Health scan, resolve these issues before
continuing. Refer to the details in the Check Health results and review the documentation.
6. Obtain the current Drive count.
From the SC interface, select Storage Systems > Physical Drives. At the top, you can see the total
number of drives. Scroll down to the bottom of the list to see all the drives installed in your system.
To see a graphical representation of the current drives, select Storage Systems > Drive Enclosure,
and then select Schematic from the View drop-down menu.
7. Remove the Bezel from the enclosure front.
a. Unlock the Bezel if necessary (1).
b. Press the release tab (2).
c. Rotate the Bezel away from the enclosure left side (3).
d. Pull the Bezel out from the enclosure right side (4).
40 Upgrade of the storage system