Host - HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual

fs Example
Component ---------Summary Description----------- Qty
fs File Services provisioning group issues
Component -Identifier- -------------------Detailed
Description--------------------
fs fsp2
FPG
fs Suggested Action
Use the CLI showfpg command to determine the state of the listed FPG. Use the CLI setfpg and
setfpg -activate commands to start the listed FPG or the CLI removefpg command to remove the
FPG if no longer wanted. For other File Services issues, use the CLI showfs, showvfs, showvfs -d
commands (and the associated set and stop commands) to investigate and solve issues.

host

• Displays Adaptive Optimization issues
• Checks that all PD classes that exist on any Node Pair are found on all Node Pairs
• Checks that FC Fabric connected host ports are configured to support Persistent Ports
• Checks that the FC switch ports are configured for NPIV support
• Checks that FC Fabric connected host partner ports are found on same FC SAN
• Checks that VLUNs are visible to their configured host through more than one Controller Node
Format of Possible host Exception Messages
Host <portID> "Port failover state is <failoverstate>, port state is <state>"
Host <portID> "Port not connected to fabric like <portID>"
Host <portID> "Port not configured as host like <portID>"
Host <portID> "Port not FC like <portID>"
Host <portID> "Port state is <state>, not ready like <portID>"
Host <portID> "Port WWN not found on FC Fabric attached to <portID>"
Host <portID> "Host port connected to FC Fabric switch port without NPIV
support"
Host <portID> "Host is not seen by multiple nodes, only seen from node
<nodeID>"
host Example 1
Component -------Summary Description-------- Qty
Host Ports not configured symmetrically
Component -Identifier- ------------Detailed Description------------
Host Port:0:1:1
host Action 1
fsp2: FPG is not activated. Corrective Action: Activate
Port not connected to fabric like Port:1:1:1
1
1
75
host