Replacing A Drive-Sp 5.X - HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual

13. From the HPE 3PAR SPOCC interface, verify that the State for the component and the storage
system are Normal (green).
14. After the component replacement, initiate Check Health of the storage system.
a. From the HPE 3PAR SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
15. Install the Bezel on the enclosure front.
a. Insert the Bezel into the enclosure right side (1).
b. Press in the release tab (2).
c. Insert the Bezel into the enclosure left side (3).
d. Lock the Bezel (4) (optional).
Figure 6: Installing an HPE 3PAR StoreServ 7000 Storage Bezel
16. Follow the return instructions provided with the replacement component.
Replacing a Drive—SP 5.x
This procedure is for the replacement of an HPE 3PAR StoreServ 7000 Storage Drive using HPE 3PAR
Service Processor (SP) 5.x.
IMPORTANT:
When replacing a Drive that is Failed, Maintenance Mode is not required. By not setting
Maintenance Mode, alerts for other issues that might arise will continue to be sent to HPE.
20 Replacing a Drive—SP 5.x