HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 19

a. On the Drive, press the release button to open the handle.
b. With the latch handle of the Drive fully extended, align and slide the Drive into the bay until the
handle begins to engage (1).
c. To seat the Drive into the Drive bay, close the handle (2).
Figure 4: Installing an HPE 3PAR StoreServ 7000 Storage SFF Drive
Figure 5: Installing an HPE 3PAR StoreServ 7000 Storage LFF Drive
Verification:
11. Observe the newly installed Drive and confirm the Fault LED is off and the Status LED is solid green.
The change in the LEDs may take several minutes as the Drive is prepared for use by the system.
12. Verify the state of the replacement Drive.
From the SSMC interface, the Drive ID that you just replaced will be removed from the list, and the
replacement Drive will be assigned a new Drive ID and be in a healthy state.
Service of the hardware components 19