Replacing An Sfp Transceiver-Sp 4.X - HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual

WARNING:
When the storage system is on, do not stare at the FC fibers, because doing so could damage your
eyes.
CAUTION:
To prevent damage when handling the SFP Transceiver, do not touch the gold contact leads.
IMPORTANT:
All SFP ports must contain an SFP Transceiver and cable or a dust cover.
Procedure
• Based on your HPE 3PAR Service Processor (SP) software version, select and complete a
replacement procedure:
◦ Replacing an SFP Transceiver—SP 4.x on page 26
◦ Replacing an SFP Transceiver—SP 5.x on page 28
Replacing an SFP Transceiver—SP 4.x
This procedure is for the replacement of an HPE 3PAR StoreServ 7000 Storage Small Form-Factor
Pluggable (SFP) Transceiver using HPE 3PAR Service Processor (SP) 4.x.
Procedure
Preparation:
1. Unpack the component and place on an ESD safe mat.
2. Connect to the HPE 3PAR Service Processor (SP).
Browse to either the IP address or hostname: https://<sp_ip_address> or https://
<hostname> .
3. Log in to the HPE 3PAR SP.
With the 3parcust account credentials, the HPE 3PAR Service Processor Onsite Customer Care
(SPOCC) interface displays.
4. Initiate a maintenance window that stops the flow of system alerts from being sent to HPE by setting
Maintenance Mode.
a. From the HPE 3PAR SPOCC interface main menu, select SPMAINT in the left navigation pane.
b. From the HPE 3PAR SPMaint interface main menu under Service Processor - SP Maintenance,
select StoreServ Configuration Management.
c. Under Service Processor - StoreServ Configuration, select Modify under Action.
d. Under Service Processor - StoreServ Info, select On for the Maintenance Mode setting.
5. Initiate Check Health of the storage system.
26 Replacing an SFP Transceiver—SP 4.x