HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual page 88

Port port:<nsp> "Port mode is in <mode> state"
Port port:<nsp> "is offline"
Port port:<nsp> "Mismatched mode and type"
Port port:<nsp> "Port is <state>"
Port port:<nsp> "SFP is missing"
Port port:<nsp>
Port port:<nsp> "SFP is disabled"
Port port:<nsp> "Receiver Power Low: Check FC Cable"
Port port:<nsp> "Transmit Power Low: Check FC Cable"
Port port:<nsp> "SFP has TX fault"
Port port:<portID> "Port listed as host path but is State:<state>, Mode:<mode> and Type:<type>"
Port port:<portID> "<count> initiators attached exceeds the supported limit of <max port count>"
Port -- "Connected <protocol> host initiators of <count> exceeds the supported limit of <max system
count>"
port Suggested Actions, General
Some specific examples are displayed below, but in general, use the following CLI commands to check
for these conditions:
For port SFP errors, use commands such as showport, showport -sfp, and showport -sfp -ddm.
port Example 1
Component ------Summary Description------ Qty
Port Degraded or failed SFPs
Component -Identifier- --Detailed Description--
Port port:0:1:1
port Suggested Action 1
An SFP in a Node-Port is reporting a degraded condition. This is most often caused by the SFP receiver
circuit detecting a low signal level (RX Power Low), and that is usually caused by a poor or contaminated
FC connection, such as a cable. An alert should identify the condition, such as the following:
Port 0:1:1, SFP Degraded (Receiver Power Low: Check FC Cable)
Check SFP statistics using CLI commands, such as showport -sfp, showport -sfp -ddm.
cli% showport -sfp 0:1:1
N:S:P -State-- -Manufacturer- MaxSpeed(Gbps) TXDisable TXFault RXLoss DDM
0:1:1 OK
--------------------------------------------------------------------------
1
In the following example an RX power level of 522 microwatts (uW) for Port 0:1:1 DDM is a good reading;
and 12 uW for Port 1:1:1 is a weak reading ( < 15 uW). Normal RX power level readings are 300-700 uW.
88 Troubleshooting
SFP is <state>" (degraded or failed)
SFP is Degraded
HP-F
1
8.5 No No No Yes