Replacing An Sfp Transceiver-Sp 5.X - HPE 3PAR StoreServ 7000 Storage Service And Upgrade Manual

a. Open the retaining clip on the SFP Transceiver.
b. Slide the SFP Transceiver out of the port slot.
Replacement:
11. Install the SFP Transceiver.
a. Open the retaining clip on the SFP Transceiver.
b. Slide the SFP Transceiver into the port slot on the controller node until fully seated.
c. Close the retaining clip.
12. Reconnect the optical cable in the same location recorded on the label.
IMPORTANT:
If an optical cable will not be connected to the SFP Transceiver, install a dust cover.
Verification:
13. Verify that the replacement SFP Transceiver has been successfully installed.
On the port with the replacement SFP Transceiver, verify that the Link Status LED is solid green and
the Port Speed LED is flashing amber.
14. From the HPE 3PAR SPOCC interface, verify that the State for the component and the storage
system are Normal (green).
15. After the component replacement, initiate Check Health of the storage system.
a. From the HPE 3PAR SPOCC interface main menu, click Support in the left navigation pane.
b. From the Service Processor - Support page, under StoreServs, click Health Check in the
Action column.
16. If significant time is left in the maintenance window, end the Maintenance Mode.
a. From the HPE 3PAR SPOCC interface main menu, select SPMAINT in the left navigation pane.
b. From the HPE 3PAR SPMAINT interface main menu under Service Processor - SP
Maintenance, select StoreServ Configuration Management.
c. Under Service Processor - StoreServ Configuration, select Modify under Action.
d. Under Service Processor - StoreServ Info, select Off for the Maintenance Mode setting.
17. Follow the return instructions provided with the replacement component.
Replacing an SFP Transceiver—SP 5.x
This procedure is for the replacement of an HPE 3PAR StoreServ 7000 Storage Small Form-Factor
Pluggable (SFP) Transceiver using HPE 3PAR Service Processor (SP) 5.x.
28 Replacing an SFP Transceiver—SP 5.x