Dialing Mode On An Analog Trunk; Default Access To A Group Of External Lines - Siemens HiPath 1100 Programming Manual

Step by step
eem
e
ddf
[1] For Bolivia and Paraguay, set "01=Brazil" for country/country group
then "02=Spanish" for language.
[2] For Indonesia set "08=Intern. Spanish" for country/group of coun-
tries. then "03=English" for language.

Dialing mode on an analog trunk

This features specifies the dialing mode to be used over
an analog trunk (DP or MF).
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter a number for an analog trunk (e.g., 801).
w
f
Enter the appropriate code:
...
e
= Analog line: Pulse (DP)
f
= Analog line: Multifrequency tone dialing (MF)
(default
for all analog lines)
w
p
Enter the next external line number.
or
w
r
Press this key.
Initial status for programming mode.
Default access to a group of external
lines
This feature configures dialing "0" for each extension as
the dialing method for a group of external lines. The de-
fault external line access code is "0."
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g. 11/101).
w
p
Enter the number for the group of external lines (e.g., 0,
890, etc).
w
p
Enter the next extension number.
or
Important settings
23