Kyocera TASKalfa 6501i Service Manual page 480

Code Contents
8010 Punch motor error 1
When the punch motor is
driven, punch home position
sensor does not turn on within
200 ms.
Related parts
Punch motor
Punch home
position sensor
Punch PWB
DF main PWB Replace the DF main PWB (Refer to the
service manual for the document finisher).
1-4-120
Check procedures/
corrective measures
1. Execute U240 Motor - Punch to check
the finisher operation (see page 1-3-
116).
2. Manipulate the punch up and down to
check it can smoothly move up and
down.
3. Check that the drive from the motor
reaches the punch cam.
4. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
Punch motor and Punch PWB (YC4)
5. If the wiring is disconnected, shorted or
grounded, replace the wiring.
6. Replace the punch motor.
1. Execute U241 Punch - Punch HP to
check the finisher switch (see page 1-3-
118).
2. Check that the sensor and its mounting
bracket are correctly positioned.
3. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
Punch home position sensor and Punch
PWB (YC8)
4. Replace the Punch home position
sensor.
1. Confirm that the wiring connector is
firmly connected and, if necessary,
connect the connector all the way in.
Punch PWB (YC1) and DF main PWB
(YC7)
2. Replace the punch PWB.
2N8/2N7