Relay Board Maintenance; Setting Of Deflection For Feeding From Dp - Kyocera TASKalfa 6501i Service Manual

Item No.
U935

Relay board maintenance

Description
Sets the mode when call for service (C0060) occurs.
Purpose
Sets the machine status temporarily when call for service (C0060) occurs. However, after the set-
ting, call for service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select Mode using the +/- keys.
Mode0
Mode1
* : Initial setting: Mode0
3. Press the start key. The setting is set.
4. Turn the main power switch off and on. Allow more than 5 seconds between Off and On.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.
U942

Setting of deflection for feeding from DP

Description
Adjusts the deflection generated when the document processor is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the
document processor is used.
Setting
1. Press the start key.
2. Press the system menu key.
3. Place an original on the DP and press the start key to make a test copy.
4. Press the system menu key.
5. Select the item to be adjusted.
6. Change the setting value using the +/- keys or numeric keys.l
Display
Front
Mix
* : The greater the value, the larger the deflection; the smaller the value, the smaller the
deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling
of original occurs, decrease the value.
7. Press the start key. The value is set.
Completion
Press the stop key.
The screen for selecting a maintenance item No. is displayed.
Display
Setting mode: OFF
Setting mode: ON (Usable up to three times of use)
Description
Deflection of single-sided original
Deflection of mixed original
Description
Description
Setting
range
-31 to 31
-31 to 31
1-3-198
2N8/2N7
Initial Change in
setting value per step
0 0.17 mm
0 0.17 mm