Kyocera TASKalfa 6501i Service Manual page 330

Item No.
U464 Setting: [Time Interval]
1. Change the setting value using the +/- keys or numeric keys.
Display
Time(sec)
2. Press the start key. The value is set.
Setting: [Mode]
1. Select the item.
Short
Normal
Long
Custom
Initial setting: Normal
2. Press the start key. The setting is set.
Setting: [On/Sleep Out]
1. Select On or Off.
On
Off
Initial setting: On
2. Press the start key. The setting is set.
Setting: [AP/NE]
1. Select On or Off.
On
Off
* : Initial setting: On
2. Press the start key. The setting is set.
Setting the interval time of calibration
Display
Setting the image adjustment execution mode: short
Setting the image adjustment execution mode: normal
Setting the image adjustment execution mode: long
Setting the image adjustment execution mode: custom
Display
At power-up: Perform calibration if the fusing temperature is
less than 50C/122F.
Recovering from Auto Sleep: Calibration is performed when 8
hours have passed since the machine has been in sleep
Not to execute calibration regardless of fuser temperature at
power-up or recovery from auto sleep mode
Display
Paper interval calibration at the time of calibration/near end
after toner feed is carried out
Paper interval calibration at the time of calibration/near end
after toner feed is not carried out
Description
Description
Description
Description
Description
1-3-176
2N8/2N7-4
Setting Initial
range setting
0 to 9999 (s) 0