Installation Environment - Kyocera TASKalfa 6501i Service Manual

1-2 Installation

1-2-1 Installation environment

1. Temperature: 10 to 32.5°C/50 to 90.5°F
(But humidity should be 70% or less when temperature is 90.5 °F (32.5 °C).)
2. Humidity: 15 to 80% RH
(But temperature should be 86 °F (30 °C) or less when humidity is 80%.)
*: Use coated paper at a temperature of 80.6 °F (27°C) or less and a humidity of 60% or less.
*: Adverse environmental conditions may affect the image quality. It is recommended to use the machine at
a temperature: around 60.8 to 80.6 °F or less (16 to 27 °C), humidity: around 36 to 65%. In addition,
Avoid the following locations when selecting a site for the machine.
The machine automatically detects and displays the following message when the environmental temper-
ature is too high or too low.
Message: "Warning for high temperature. Adjust the room temperature." or "Warning for low tempera-
ture. Adjust the room temperature."
To use the machine under optimum conditions, adjust the temperature and the humidity of your room if
the message is displayed.
3. Power supply: 120 V AC, 16.0 A
4. Power source frequency: 50 Hz ± 2%/60 Hz ± 2%
5. Installation location
Avoid direct sunlight or bright lighting. Ensure that the photoconductor will not be exposed to direct sun-
light or other strong light when removing paper jams.
Avoid locations subject to high temperature and high humidity or low temperature and low humidity; an
abrupt change in the environmental temperature; and cool or hot, direct air.
Avoid places subject to dust and vibrations.
Choose a surface capable of supporting the weight of the machine.
Place the machine on a level surface (maximum allowance inclination: 1).
Avoid air-borne substances that may adversely affect the machine or degrade the photoconductor, such
as mercury, acidic of alkaline vapors, inorganic gasses, NOx, SOx gases and chlorine-based organic sol-
vents.
Select a well-ventilated location.
*: If the floor is delicate against casters, when this machine is moved after installation, the floor material
may be damaged.
*: During copying, some ozone is released, but the amount does not cause any ill effect to one's health. If,
however, the machine is used over a long period of time in a poorly ventilated room or when making an
extremely large number of copies, the smell may become unpleasant.
To maintain the appropriate environment for copy work, it is suggested that the room be properly venti-
lated.
220 - 240 V AC, 9.5 A
1-2-1
2N8/2N7-4