Remarks On Main Pwb Replacement - Kyocera TASKalfa 6501i Service Manual

Hide thumbs Also See for TASKalfa 6501i:

Table of Contents

(2) Remarks on main PWB replacement

When replacing the main PWB, remove the EEPROM (YC14) and DIMM (YS1,YS3) from the main PWB that

has been removed and then reattach it to the new main PWB.

When refitting DIMM, Refit them to the original positions.

* : YS1:1GB YS3:1GB

If the main PWB was replaced with a service supplied part, perform the following.

1. Insert the USB flash device in which an upgrade pack of the latest firmware or the Main/MMI/Browser

and Language BR (excluding Dictionary) were copied, into the slot on the machine and turn power on.

(see page 1-6-1).

2. After the main-circuit PWB has been replaced, perform U026 to restore backed-up data.

*: Do not replace the main-circuit PWB and the HDD at the same time.

(Otherwise, the settings retained by U026 in the HDD will not become restorable.)

*: Referring to the U000 maintenance report printed previously, enter the following values.

U278 Setting the delivery date

U402 Adjusting margins of image printing

U952 Maintenance mode workflow

*:Since the U952 settings are not printed on the maintenance report, perform U952 to register settings

Figure 1-5-128

Figure 1-5-129

Show Quick Links

Table of Contents

Taskalfa 8001i