Punch Width; Width Front Hp/Width Tail Hp; Shift Front Hp/Shift Tail Hp - Kyocera TASKalfa 6501i Service Manual

Item No.
U246 Setting: [Punch Width]
1. Select [Punch Width].
2. Change the setting value using the +/- keys or numeric keys.
Adjustment of the punch center position timing -4 to 4
* : If the punch hole is too close to the front of the machine, increase the setting value. If the
punch hole is too close to the rear of the machine, decrease the setting value.
3. Press the start key. The value is set.
Setting: [Width Front HP/Width Tail HP]
1. Select [Width Front HP] or [Width Tail HP].
2. Change the setting value using the +/- keys or numeric keys.
Adjustment of front side registration home position
Adjustment of rear side registration home position
3. Press the start key. The value is set.
4. Press the stop key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select [Motor], then [Width Test(A3)].
The width guides of the middle tray will move to A3-size position.
6. Pull the middle tray, insert paper between the guides and check that paper is abut the guides.
7. Repeat the above adjustment until paper is properly in position.
Setting: [Shift Front HP/Shift Tail HP]
1. Select [Shift Front HP] or [Shift Tail HP].
2. Change the setting value using the +/- keys or numeric keys.
Adjustment of front shift home position
Adjustment of rear shift home position
3. Press the start key. The value is set.
4. Press the stop key. The screen for selecting a maintenance item No. is displayed.
5. Enter maintenance mode U240 and select [Motor], then [Sort Test].
6. Repeat the above adjustment until eject paper is properly in position.
Description
Center line
(within ± 0.5 mm)
Description
Description
Description
Setting
range
Sample 1
Figure 1-3-34
Setting
range
-15 to 15
-15 to 15
Setting
range
-15 to 15
-15 to 15
1-3-125
Initial Change in
setting value per step
0 0.52 mm
Sample 2
Initial Change in
setting value per step
0 0.19 mm
0 0.19 mm
Initial Change in
setting value per step
0 0.19 mm
0 0.19 mm
2N8/2N7