Setting The Maintenance Item U952; Exit Maintenance Mode; Completion Of The Machine Installation; Adjusting The Image - Kyocera TASKalfa 6501i Service Manual

Hide thumbs Also See for TASKalfa 6501i:

Table of Contents

2. Setup setting at high altitude place.

When setup is done at high altitude place, execute as follows (such as in Mexico City). (see page 1-3-

U140 -> AC Calib -> Calibration -> Execute -> Start

Result: developing leak image occur (see page 1-4-220).

U140 - AC Calib -> Lowering the numerical value of Magnification

3. Drum refresh (see the operation guide)

Press the System menu key.

Press [Adjustment/Maintenance] and then [Next] of [Drum Refresh].

Press [Execute] to perform drum refresh. When completed, press [OK].

Setting the maintenance item U952 (see page 1-3-199)

1. Enter the maintenance mode by entering 10871087 using the numeric keys.

2. Enter 952 using the numeric keys and press the start key.

3. Select [Execute].

4. Select [SETUP].

5. Press the start key.

*: Running the simulation allows execution histories to be logged.

1. Enter 001 using the numeric keys and press the start key. The machine exits the maintenance mode.

*: The maintenance mode U952 [SETUP] includes the following:

If U952 is not used, follow the procedure below.

1. Performing calibration

U464 Setting the ID correction operation - performing calibration (see page 1-3-175)

*: See the operation guide

Press [Adjustment/Maintenance] and then [Next] of [Calibration].

Press [Execute] to perform calibration. When completed, press [OK].

2. Adjusting the halftone automatically (see page 1-3-151)

Load the cassette with multiple sheets of A4 or Letter paper.

Show Quick Links

Table of Contents

Taskalfa 8001i