Kyocera TASKalfa 6501i Service Manual page 583

(18) The leading edge of the image is sporadically misaligned with the original.
Print example
Defective part
Paper feed clutch,
Middle clutch, Reg-
1
istration clutch,
Duplex clutch
Paper feed clutch,
Middle motor, Reg-
istration motor,
2
Duplex motor
(19) Paper is wrinkled.
Print example
Defective part
Paper-width guides Check the paper-width guides
1
Paper
2
Regist roller
3
Fuser unit
4
Check description
Check that the clutches are
properly fit.IOr, check they are
operative without a hinderance.
(35 ppm model)
Check that the clutches and
motors are properly fit.Or, check
they are operative without a
hinderance. (45 ppm/ 55 ppm
model)
Check description
are flush with the paper.
1. Check if paper is curled or
wavy.
2. Check if paper is stored in a
humid place.
The pressures at the front and
back springs are unbalanced.
The pressuring spring of the
fuser unit is defective.
1. If it is not fixed properly, fix it properly.
2. If it does not operate without a hinderance,
replace the clutch.
1. If it is not fixed properly, fix it properly.
2. If it does not operate without a hinderance,
replace the clutch or motor.
If the width adjuster cursors are not flush with
paper, set them correctly.
1. If the paper is curled or wavy, replace.
2. Choose a dry place to store paper.
Replace the spring with the one having a
correct pressure.
Replace the fuser unit. (see page 1-5-67)
1-4-223
Corrective Action
Corrective Action
2N8/2N7