Kyocera TASKalfa 6501i Service Manual page 736

4. Remove the right hinge cover.
5. Turn adjusting screw at the rear side of
the right hinge to adjust the DP position.
For copy example 1:
Turn the adjusting screw counterclock-
wise and move the DP to the inner side.
For copy example 2:
Turn the adjusting screw clockwise and
move the DP to the front side.
Amount of change per scale: Approx. 1
mm
6. Make a test copy.
7. Repeat the steps above until the gap of
the leading edge falls within the refer-
ence values.
8. After adjustment is completed, retighten
two screws that have been loosened in
step 3.
9. Remove the original mat.
10. Place original mat with its Velcro
upward over the contact glass.
*: Align original mat corner that has 90
degrees of angle with the inner left cor-
ner of the original instruction panel.
11. Close DP and attach original mat onto it
with Velcros.
Adjusting screw
Figure 1-5-205
Original mat
Velcros
Original mat
Figure 1-5-206
1-5-124
2N8/2N7
Right hinge cover
DP
Velcros