Relay Board Maintenance; Setting Of Deflection For Feeding From Dp - Kyocera KM-3050 Service Manual

2GN/2GP/2GR-7
Maintenance
item No.

Relay board maintenance

U935
Description
Sets the machine status temporarily when call for service (C0060) occurs. However, after the setting, call for
service (C0060) occurs again when progress of period.
Setting
1. Press the start key.
2. Select the item.
Display
MODE 0
MODE 1
Initial setting: MODE 0
3. Press the start key. The setting is set.
4. Turn the main power switch off and on.
Supplement
After removing the cause of the problem, be sure to change the setting in OFF.

Setting of deflection for feeding from DP

U942
Description
Adjusts the deflection generated when the optional DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Setting
1. Press the start key.
2. Select the item to be adjusted.
Display
REGIST
REGIST MIX
3. Press the system menu key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the system menu key.
6. Change the setting value using the +/- or numeric keys.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
7. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-86
Description
Setting mode: OFF
Setting mode: ON (Usable up to three times of use)
Description
Deflection in the reading original from
the DP
Deflection in the reading original from
the DP in the auto selection mode
Description
Setting
range
-31 to 31
-31 to 31
Initial Change in
setting value per step
0 0.17 mm
0 0.17 mm