Setting Editing Points - Sony PCM-3348HR Quick Reference

21. Editing

21-3. Setting Editing Points

Setting the editing IN point on the recorder
Use the normal procedure to store the punch-in point on the recorder.
Setting the editing IN point on the player
1
Press the SLAVE button on the player RM-3324/3348HR, turning it off.
2
Use the normal procedure to store the punch-in point on the player.
Setting the editing OUT point on the recorder
Use the normal procedure to store the punch-out point on the recorder.
If the recorder editing OUT point is not set, the editor mode will not operate
correctly. Even for assemble editing, where the punch-out point does not normally
need to be set, set the editing OUT point at a point near the end of the tape.
Setting the editing OUT point on the player
Although it is possible to set the player editing OUT point, it is not required for
editing operations.
Correcting time values after using the search knob for cuing
1
Turning the search knob for playback, find the editing IN point.
2
Press the ↓ button on the remote control unit.
3
Use the SF.mS/F.S button to set the LOCATE TIME display units to
milliseconds.
4
•
When the sampling frequency is 44.056 kHz or 44.1 kHz
Press the +, 6, 9, =, STORE and IN buttons in that order.
•
When the sampling frequency is 48.0 kHz
Press the +, 6, 3, =, STORE and IN buttons in that order.
56
Editing