Table of Contents
Advertisement
3 Installing the
Autosampler
The autosampler is designed for easy installation. Installation consists of two
parts: assembling the autosampler and connecting it to the host analytical
instrument.
The autosampler can be installed with minimal effort; no tools are required.
You can remove thumbscrews with tools if necessary, but do not tighten them
with anything other than your fingers.
To install the autosampler, you must complete the following tasks. Each of
Overview
these tasks will be discussed in detail later in this chapter.
Mount the sample probe assembly.
Connect the rinse station.
Assemble and place the sample racks and standards vials.
Establish external connections.
Connect the ASX-112FR autosampler to the host computer.
Ensure the power switch is off and the power cord is unplugged before
WARNING
proceeding with installation. If the power is left on, motors may move
unexpectedly and cause injury.
19
Advertisement
Table of Contents
