Remarks - Ricoh G-P2 Service Manual

G160 Service Manual
Method: Press the "Up/Down arrow" keys together for about 5 seconds, and then press the
"OK" key.
"SYSTEMver x.xx/ 1. Service" appears on the display.
The machine automatically goes off line when you enter the service mode.
Accessing the Required Program
Use the "Up/Down arrow" keys to scroll through the menu listing.
1. Service: Controller service modes
2. Engine: Engine service modes
3. End: Exit service mode
To select an item, press the "OK" key. Then the sub-menu shows.
Scroll through the sub menu items using the "
To go back to a higher level, press the "Escape" key.
Inputting a Value or Setting for a Service Program
Enter the required program mode as explained above. The setting appearing on the display
is the current setting.
Select the required setting using the "
value remains if the "OK" key is not pressed.
Exiting Service Mode
Select "End" from the service mode main menu, then press the "OK" key.
To make the settings effective, turn the main switch off and on after exiting service
mode.

Remarks

Display on the Control Panel Screen
Since the maximum number of characters which can be displayed on the control panel
screen is limited (12 or 17 characters), the description of SP modes displayed on the screen
needs to be abbreviated. The following are the major abbreviations used for the SP modes
for which the full description is over 12 or 17 characters.
1. Paper Type
N: Plain paper 1, N2 or Normal 2: Plain paper 2 (plain & recycled)
" keys.
" keys, then press the "OK" key. The previous
60
23-Feb-06