Electrical Components; Controller Board - Ricoh G-P2 Service Manual

G160 Service Manual

Electrical Components

Before you replace the EGB (Engine Board), the controller, or the NVRAM, print
out the SMC reports ("SP Mode Data" and "Logging Data").
After you replace the EGB (Engine Board) or the controller, remove the NVRAM
from the old board and install it on the new board. If the NVRAM on the old
board is defective, replace the NVRAM (see 'NVRAM Replacement
Procedure').

Controller Board

1. Controller unit [A] (
2. Controller unit cover [B] (
x 3)
x 4)
13
23-Feb-06