Ricoh G-P2 Service Manual page 193

G160 Service Manual
7803 005 S: PCU: [Y]
7803 009 S: Transfer Belt Unit
7803 010 S: T. Roll 2
7803 011 S: Fusing Unit
7803 012 S: By-pass
7803 013 S: Tray 1
7803 014 S: Tray 2
7803 015 S: Tray 3
7803 017 R: PCU: [K]
7803 018 R: PCU: [M]
7803 019 R: PCU: [C]
7803 020 R: PCU: [Y]
7803 025 R: Trans Belt Unit
7803 026 R: T. Roll 2
7803 027 R: Fusing Unit
7803 033 Toner Supply: [K]
7803 034 Toner Supply: [M]
7803 035 Toner Supply: [C]
7803 036 Toner Supply: [Y]
7803 037 R%: PCU: [K]
7803 038 R%: PCU: [M]
7803 039 R%: PCU: [C]
7803 040 R%: PCU: [Y]
7803 045 R%: Trans Belt Unit
7803 046 R%: T. Roll 2
7803 047 R%: Fusing Unit
*EGB PM counter value is automatically moved to
the PM Counter - Previous (SP7-906-1 to 10)
*EGB
and is reset to "0".
*EGB
The total number of sheets printed with the
*EGB
last unit replaced can be checked with
*EGB
SP7-906-1 to 10.
*EGB
SP7-803-001: This shows the number of
*EGB
pages printed.
*EGB
[0 to 9999999 / 0 / 1 sheet/step]
*EGB Displays the number of revolutions of motors
or clutches for each current maintenance unit.
*EGB
[0 to 9999999 / 0 / 1 revolution/step]
*EGB
When a unit is replaced, the machine
*EGB
automatically detects that the new unit is
*EGB
installed. Then, the current PM counter value
*EGB
is automatically moved to the PM Counter -
Previous (SP7-906-11 to 20) and is reset to
"0". The total number of revolutions made with
*EGB
the last unit replaced can be checked with
SP7-906-11 to 20.
[0 to 9999999 / 0 / 1 rotation/step]
*EGB
Displays the number of sheets printed until
*EGB the waste toner bottle becomes full or toner
runs out.
*EGB
[0 to 9999999 / 0 / 1 /step]
*EGB
*EGB Displays the value given by the following
formula:
*EGB
(Current revolution / Target revolution) 100,
*EGB
where "Current revolution" is the current value
*EGB
for the counter of the part, and "Target
*EGB
revolution" is the values of SP7-803-17
*EGB
through 27. This shows how much of the unit's
expected lifetime has been used up.
The R% counter is based on rotations, not
*EGB
prints. If the number of rotations reaches the
limit, the machine enters the end condition for
186
23-Feb-06