Ricoh G-P2 Service Manual page 184

G160 Service Manual
Selects the method for transmitting log information.
0: Transmitting OFF, 1: Always Transmitting, 2: Interval Transmitting
5849 [Installation Date]
5849 001 Display
5849 003 Total Counter
5851 [Bluetooth]
5851 001 Mode
5856 [Remote ROM Update]
5856 002 Local Port
5857 [Debug Log Save]
5857 001 ON/ OFF
5857 002 Target
5857 005 Save to HDD
5857 006 Save to SD Card
5857 009 HDD to SD Latest
5857 010 HDD to SD Any
5857 011 Erase HDD Debug
Enables or disables the udirectory access
*CTL limitation.
0000: Disabled, 0001: Enabled
*CTL
Adjusts the Bluetooth setting.
*CTL
[0 or 1 / 0 / -]
0: Public, 1: Private
Allows the technician to update the firmware
using a parallel cable.
[0 or 1 / 0 / 1/step]
0: Disable, 1: Enable
Enables Or Disables The Debug Log Saving
Function.
*CTL
[0 or 1 / 0 / 1/Step] Alphanumeric
0: OFF, 1: ON
Sets the storage location for the debug log.
*CTL [2 or 3 / 2 / 1/step]
2: HDD, 3: SD
*CTL Sets the key number of the debug log.
*CTL Sets the key number of the debug log.
Copies the most recent 4 MB of the debug log
*CTL
from the hard disk to the SD card.
Sets the key number of the debug log copied
*CTL
from the hard disk to the SD card.
*CTL Deletes the debug log from the hard disk.
177
23-Feb-06