Ricoh G-P2 Service Manual page 50

G160 Service Manual
SC
Symptom
[Level]
[D] An error was detected in the handling of the log data at power on or during
machine operation. This can be caused by switching the machine off while it is
operating.
1. Initialize the HDD with SP5832-004.
Log Data Error 2
002
The DESS module is not installed when the DESS module is set to ON.
[D]
1. Replace the DESS module.
2. Turn off the DESS module function.
Log Data Error 3
003
Invalid encryption key log due to defective NVRAM data
[D]
1. Initialize the HDD with SP5832-004.
2. Disable the log encryption setting.
Log Data Error 4
004
Unusual encryption function log due to the defective NVRAM data
[D]
1. Initialize the HDD with SP5832-004.
Log Data Error 5
005
NVRAM or HDD, which is used in other machine, is installed.
[D]
1. Reinstall the previous NVRAM or HDD.
2. Initialize the HDD with SP5832-004.
Log Data Error 99
099
Other than above causes
[D]
1. Ask your supervisor.
HDD Data Overwrite Security SD card error
The all delete cannot be
877
executed even though the
[B]
Data Overwrite Security Unit
(B735) is installed and
activated.
Electric counter error
900
Abnormal data is stored in the
[D]
counters.
Possible Cause/Required Action
Defective SD card (B735)
Not installed SD card (B735)
1. Replace the NVRAM and then install the
new SD card (B735).
2. Check and reinstall the SD card (B735).
Defective NVRAM
Defective controller
1. Turn the main switch off and on.
2. Check the connection between the
43
23-Feb-06