Ricoh G-P2 Service Manual page 155

G160 Service Manual
3523 001 MIN [K]
3523 002 MIN [M]
3523 003 MIN [C]
3523 004 MIN [Y]
[M/A Target] ([Color])
3531
3531 001 [K]
3531 002 [M]
3531 003 [C]
3531 004 [Y]
[TD Setting] Toner Density Adjustment Setting
3541
3541 001
[PC SelfChk] Process Control Self-check
3551
3551 001 Job End 1: [K]
3551 002 Job End 1: [Cl]
3551 003 Job End 2: [K]
3551 004 Job End 2: [Cl]
3551 005 Job End 3: [K]
3551 006 Job End 3: [Cl]
3553 [PC SelfChk]
3553 001 Idle Time
*EGB
Adjusts the minimum development bias for
*EGB
each color.
*EGB
[1 to 800 / 150 / 1 V/step]
*EGB
Adjusts the maximum toner target M/A for
*EGB each mode.
[0.000 to 1.000 / 0.53 / 0.001 mg/step]
*EGB
[0.000 to 1.000 / 0.500 / 0.001 mg/step]
*EGB
*EGB
[ 0 or 1 / 0 / -]
*EGB
0: On, 1: Off
*EGB At the end of a job, process control is done
after the interval of time that is set with SP
3555 001, if this number of pages was printed
*EGB
after the previous process control.
[0 to 2000 / 210 / 1 page/step]
*EGB At the end of a job, process control is done
immediately, if this number of pages was
printed after the previous process control.
*EGB
[0 to 2000 / 300 / 1 page/step]
*EGB In the middle of a job, printing stops and
process control is done if the number of pages
in the job gets to this number.
*EGB
[0 to 2000 / 500 / 1 page/step]
Adjusts the threshold time for the self check
*EGB
without the machine operation.
148
23-Feb-06