Ricoh G-P2 Service Manual page 185

G160 Service Manual
5857 012 Erase SD Debug
5857 013 Dsply-SD Space
5857 014 SD to SD Latest
5857 015 SD to SD Any
5857 016 Make HDD Debug File *CTL
5857 017 Make SD Debug File
5858 [Debug Log Save: SC]
5858 001 Engine SC
5858 002 Controller SC
5858 003 Any SC
5858 004 Jam
5859 [Debug Log Save Key]
5859 001 Key 1
5859 002 Key 2
*CTL Deletes the debug log from the SD card.
*CTL Shows the free space on the SD card.
Copies the most recent 4 MB of the debug log
*CTL
from an SD card to a different SD card.
Sets the key number of the debug log copied
*CTL
from an SD card to a different SD card.
Makes a log file on the HDD to save debug
logs. To save debug logs, the controller makes
a log file first, then writes data in the file. This
procedure can use much time. The user can
switch off the main power switch before the
log is written in the file. To prevent this
*CTL
possible problem, you can prepare a log file in
advance. If you do this, the controller uses
less time to save logs because the log file is
prepared.
Collects debug logs when an engine-related
SC code occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Collects debug logs when a controller-related
SC code occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
Sets the SC code whose logs are collected.
*CTL
[00000 to 65535 / 0 / 1/step]
Collects debug logs when a paper jam occurs.
*CTL
[0 or 1 / 0 / 1/step]
0: OFF, 1: ON
*CTL Sets the key number of a specific event (see
the note below) whose logs are saved in the
*CTL
178
23-Feb-06