Ricoh G-P2 Service Manual page 51

G160 Service Manual
SC
Symptom
[Level]
Printer function error
920
The error that causes the
[B]
malfunction in the software
application is detected.
Printer font error
No font is detected in the
921
machines that have the font in
[B]
the SD card when the printer
application is run.
Software performance error 1
990
The software makes an
[D]
unexpected operation.
Software performance error 2
Unexpected software error
991
detected, which does not
[C]
affect operation of the
machine
SC not defined
992
SC that is not controlled in the
[D]
system occurs.
Application start error
998
No applications start within 60
[D]
seconds after the power is
turned on.
Possible Cause/Required Action
NVRAM and controller.
3. Replace the NVRAM.
4. Replace the controller.
Turn the main switch off/on, or install Printer
Application firmware
Unexpected hardware structure (insufficient
memory or hard disk space.)
Install the System, Printer Application, NIB,
and Web System firmware.
Defective software
Defective controller
Software error
1. Reinstall the controller and/or engine
main firmware.
2. See the Note at the end of the SC table.
The machine does not stop and the SC code is not
displayed. The machine automatically recovers.
However, the SC code is logged in the engine
summary sheet (SMC).
Defective system software
Loose connection of RAM, DIMM and SD card
in slot 1
Defective controller
Software problem
44
23-Feb-06