Table of Contents
Advertisement
3. Align the notch on the SO-DIMM memory module with the notch in the SO-DIMM memory socket.
4. Insert the SO-DIMM memory module into the corresponding socket at a 30-degree angle.
5. Rotate the SO-DIMM memory module down until it snaps into place and the levers close.
Visually check that each lever latch is fully closed and correctly engaged with the notch
on the memory module edge.
6. Repeat step 2 - 5 to install the second SO-DIMM memory module in case two DIMM memory modules are required.
Use memory modules with the same memory density in both socket!
In case only one memory module is installed, we suggest installing it on the socket
DIMM1.
7. In order to close the device, proceed step 6 - 7 described in the subsection 5.1 "Opening and Closing the Chassis".
5.1.2. Installing An M.2 Key M SSD
To install an M.2 Key M SSD please proceed according to the steps described:
1. Open the device as described in the subsection 5.1 "Opening and Closing the Chassis" (step 1 - 5).
2. Locate the M.2 Key M socket (M2M1) (Figure 6, pos. 2) and the corresponding fixing bolt (Figure 6, pos. 3).
3. Align the notch on the M.2 SSD with the notch in the M.2 socket. Insert the M.2 SSD into the corresponding socket
and rotate it down with the fixing hole of the M.2 SSD over the fixing bolt.
4. Press the M.2 SSD down on the side with the fixing hole and secure it with the available fastening screw.
5. In order to close the device, proceed step 6 - 7 described in the subsection 5.1 "Opening and Closing the Chassis".
5.1.3. Installing An M.2 Key B Expansion Card / SSD
To install an M.2 Key B expansion card / SSD please proceed according to the steps described:
1. Open the device as described in the subsection 5.1 "Opening and Closing the Chassis" (step 1 and 8 - 12).
2. Locate the M.2 Key B socket (M2B1) (Figure 5, pos. 1) and the corresponding fixing bolt (Figure 5, pos. 4 for Type
2280 card and Figure 5, pos. 5 for Type 2242 / 3042 card).
3. Align the notch on the M.2 expansion card / SSD with the notch in the M.2 socket. Insert the M.2 expansion card /
SSD into the corresponding socket and rotate it down with the fixing hole of the M.2 expansion card / SSD over the
corresponding fixing bolt.
4. Press the M.2 expansion card / SSD down on the side with the fixing hole and secure it with the available
fastening screw.
5. In order to close the device, proceed step 13 - 14 described in the subsection 5.1 "Opening and Closing the Chassis".
An additional screwable fixing bolt extension is provided for Type 2242 / 3042 card.
Screw the fixing bolt extension to the corresponding fixing bolt (Figure 5, pos. 5) in case
of a Type 2242 / 3042 card used.
5.1.4. Installing An M.2 Key E Expansion Card
To install an M.2 Key E expansion card please proceed according to the steps described:
www.kontron.com
KBox F-420-WLU - User Guide, Rev. 1.0
// 32
Advertisement
Table of Contents
