Pci Express Mini Card Installation; Rear I/O Device Installation; Battery Replacement - Kontron CP308 User Manual

Installation
3.5.7

PCI Express Mini Card Installation

The 8HP CP308 equipped with the CP308-MEDIA module provides a PCI Express Mini Card
connector for installing a PCI Express Mini Card. The CP308-MEDIA module supports PCI Ex-
press Mini Cards such as PCI Express Mini Card SSD, PCI Express Mini Card WLAN, PCI Ex-
press Mini Card Bluetooth, etc. For further information regarding the CP308-MEDIA module,
refer to Appendix B in this manual.
Note ...
The CP308-MEDIA does not support removal and reinsertion of the PCI Ex-
press Mini Card while the board is in a powered-up state. Connecting the PCI
Express Mini Card while the power is on may damage your system.
3.5.8

Rear I/O Device Installation

For physical installation of rear I/O devices, refer to the documentation provided with the device
itself.
Note ...
VGA and Ethernet can be used either on the front panel or on the rear I/O.
SATA 4 and 5 as well as COM1 can be used either on the 8HP expansion
module or on the rear I/O. It is not possible to use any of the above-mentioned
interfaces on the front or the 8HP expansion and on the rear I/O simulta-
neously.
3.5.9

Battery Replacement

The lithium battery must be replaced with an identical battery or a battery type recommended
by the manufacturer. A suitable battery type is CR2025.
Note ...
The user must be aware that the battery's operational temperature range is
less than the CP308's storage temperature range.
For exact range information, refer to the battery manufacturer's specifications.
Note ...
Care must be taken to ensure that the battery is correctly replaced.
The battery should be replaced only with an identical or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
The typical life expectancy of a 170 mAh battery (CR2025) is 5 - 6 years with
an average on-time of 8 hours per working day at an operating temperature of
30°C. However, this typical value varies considerably because the life
expectancy is dependent on the operating temperature and the standby time
(shutdown time) of the system in which it operates.
To ensure that the lifetime of the battery has not been exceeded it is
recommended to exchange the battery after 4 - 5 years.
Page 3 - 12
CP308
ID 1027-4487, Rev. 3.0