<m>
(Parameter shows the subscriber CLIR service status in the network)
0
1
2
3
4
12.10. AT+COLP Connected Line Identification Presentation
AT+COLP Connected Line Identification Presentation
Test Command
AT+COLP=?
Read Command
AT+COLP?
Write Command
AT+COLP=[<n>]
Reference
GSM 07.07
Parameter
<n>
(Parameter sets/shows the result code presentation status in the TA)
0
1
<m>
(Parameter shows the subscriber COLP service status in the network)
0
1
2
NOTE
M35_AT_Commands_Manual
CLIR not provisioned
CLIR provisioned in permanent mode
Unknown (e.g. no network, etc.)
CLIR temporary mode presentation restricted
CLIR temporary mode presentation allowed
Response
+COLP: (list of supported <n>s)
OK
Response
+COLP: <n>,<m>
OK
Response
TA enables or disables the presentation of the COL
(Connected Line) at the TE for a mobile originating a call. It
has no effect on the execution of the supplementary service
COLR in the network.
Intermediate result code is returned from TA to TE before any
+CR or V.25ter responses.
OK
Disable
Enable
COLP not provisioned
COLP provisioned
Unknown (e.g. no network, etc.)
Confidential / Released
GSM/GPRS Module
M35 AT Commands Manual
164 / 182