Software Requirements For Commissioning On Profibus Dp; Requirements For Commissioning The Et 200S On Profibus Dp; Procedure For Commissioning The Dp Slave; Commissioning And Startup Of The Et 200S On Profibus Dp - Siemens SIMATIC ET 200S Manual

Commissioning and Diagnostics
6.1.2

Commissioning and startup of the ET 200S on PROFIBUS DP

Software requirement NONE
Table 6-3

Software requirements for commissioning on PROFIBUS DP

Engineering software
used
STEP 7
COM PROFIBUS
Configuration software
for a different DP
master
Requirements for commissioning the ET 200S
Table 6-4

Requirements for commissioning the ET 200S on PROFIBUS DP

Prior Activity
1. DP slave installed
2. PROFIBUS address set on the DP slave
3. DP slave wired
4. DP slave configured (configured and parameters assigned)
5. Supply voltage switched on for DP master
6. DP master set to RUN mode
Commissioning the ET 200S
Table 6-5

Procedure for commissioning the DP slave

Step
1. Switch on the supply voltage for the DP slave.
2. Switch on the supply voltage for the load as necessary.
6-10
Version
As of Version 5.0 You are using HW Config. As of ServicePack 3 the
and ServicePack 3 ET 200S is included in the hardware catalog.
As of Version 5.1, You have integrated the device database file of ET 200S
ServicePack 2, in COM PROFIBUS.
Hotfix 1
You need the device database file of ET 200S.
Procedure
Notes
See ...
Chapter 4
Section 4.8
Chapter 5
Section 6.1.1
DP master manual
DP master manual
See .
Section 8.2
ET 200S Distributed I/O System
EWA-4NEB 780602402-12